Sale!

Ascher Racing F64-USB V3

1,425$CAD

  • Platform independent USB connection
  • 285mm diameter
  • Maximum grip level from closed, ergonomic rubber grips
  • 14 x push buttons with tactile feeling
  • 2 x multifunctional 7-way joysticks
  • 2 x encoders (inc. push button functionality)
  • 2 x 12-position rotary switches
  • 2 x thumb encoders
  • Magnetic paddle shifters
  • Contactless motorsport clutch paddles

Only 1 left in stock

Category:

Description

64 Inputs

  • 14 x push buttons with positive tactile feeling
  • 2 x protective button guards
  • 2 x multifunctional 7-way joysticks
  • 2 x encoders inc. push button functionality, aluminium knob
  • 2 x thumb encoders
  • 2 x 12-position rotary switches, aluminium knob
  • 2 x paddle shifters
  • 2 x clutch paddles with electronic bite-point calibration

 

Button Labels

  • 50 pcs button labels each black and white
  • 72 pcs encoder labels (blue, green, red, black, yellow, white)
  • labels for various common steering wheel inputs

 

General Information

  • 285 mm wheel diameter
  • 6 x 70 mm bolt pattern
  • robust, shielded coiled cable with industrial Binder M16 connector
  • coiled cable connector length approx. 64mm
  • spacer may be required to create sufficient clearance to the wheel base
  • M5 x 12 mm stainless screws to mount QR included
  • Quick Release not included
  • to mount M5 threaded QRs, use captive screws
  • mass: 1140 g

Compatible Wheelbases

  • Simucube 2 
  • Simucube 1 (OSW, Mige) 
  • Accuforce*
  • Leo Bodnar** 
  • OSW (Argon)**
  • Simagic*
  • VRS Direct Force*** 
  • Fanatec Podium Hub*

 

captive screws   are required
** Wheelbase comes without QR
*** longer screws are required 

Additional information

Weight 8 lbs
Dimensions 19 × 13 × 6 in

Electronic bite-point calibration

  • precise adjustments in 1.0 % and 0.1 % increments
  • change bite-point via configuration tool or directly on the wheel rim:
    1. push both joystick buttons for 1s to acces bite-point mode
    2. LED lights up to indicate calibration mode
    3. rotate left joystick for 1.0 % increments / right joystick for 0.1 % increments (LED flashes to indicate changes)
    4. exit calibration mode by pushing both joysticks again for 1s
  • recommended procedure for finding best setting:
    1. enter calibration mode and set bite-point to high value, e.g. 80 %
    2. pull slave clutch only
    3. apply throttle
    4. reduce bite-point in 1.0 % increments (left joystick) until vehicle starts moving
    5. make test starts to fine tune desired bite-point setting
    6. exit bite-point calibration mode
  • recommended procedure for quick race starts
    1. pull both master and slave clutches
    2. apply throttle
    3. race start -> let master clutch snap
    4. it will take less than 20 ms to reach desired bite-point
    5. slowly release slave clutch